| 剪切机操作规程 |
| 添加时间：2017/8/11 14:31:06 浏览次数： |
| 操作规程 Operating procedures 第一：认真执行《锻压设备通有操作规程》有关规定。 First: to carry out the regulations on the operation of forging equipment. 第二：认真执行下述有关补充规定： Secondly, the following supplementary provisions are carefully implemented: 1、工作前认真作到： 1. Carefully before work: 1）、在空运转试车之前，应先用人工盘车一个工作行程，确认正常后才能开动设备。[1] 1) before the empty operation test, a working schedule should be used to make sure that the equipment can be started after normal operation. [1] 2）、有液压装置的设备、检查储油箱油量应充足。启动油泵后检查阀门、管路是否有泄漏现象，压力应符合要求。打开放气阀将系统中的空气放掉。 2) the equipment of hydraulic installation and inspection of oil storage tank should be sufficient. Check valve and pipeline after starting oil pump, and the pressure should meet the requirement. Open the air valve to release the air in the system. 2、工作中认真做到： 2. Work carefully: 1）、不准剪切叠合板料，不准修剪毛边板料的边缘，不准剪切压不紧的狭窄板料和短料。 1) it is not allowed to cut the laminated sheet material, not to trim the edges of the edges of the edges, and it is forbidden to shear the narrow plates and short materials that are not tight. 2）、刀板间的间隙应根据板料的厚度来调正，但不得大于板最的1/30。刀板应紧固牢靠，上、下刀板面保持平行，调正后应用人工盘车检验，以免发生意外。[2] 2) the clearance between the blades shall be adjusted according to the thickness of the sheet, but shall not be greater than 1/30 of the plate. The knife plate should be firmly fixed, and the upper and lower blade shall be kept parallel. After adjusting, the plate shall be tested to avoid any accidents. [2] 3）、刀板刃口应保持锋利，如刃口变钝或有崩裂现象，应及时更换。 3) the edge of the blade should be kept sharp. If the edge of the blade becomes dull or cracked, it should be replaced in time. 4）、剪切时，压料装置应牢牢地压紧板料，不准在压不紧的状态下进行剪切。 4) when shearing, the pressure material should be firmly pressed on the plate, and no shear should be done in the state of pressure. 5）、有液压装置的设备，除节流伐外其他液压阀门不准私自调正。 5) equipped with hydraulic equipment, other hydraulic valves are not allowed to adjust themselves. 6）、 对于液压摆式剪板机[3]剪切板料的厚度，应根据《板料极限强度与板厚关系曲线图》来确定。[4] 6) for the thickness of [3] shearing sheet for hydraulic swing shears, it should be determined according to the relationship curve of sheet material limit strength and plate thickness. [4] 3、工作后应将上刀板落在最下位置上。 3. After work, the upper blade should be placed in the lowest position. |
| 上一页 剪切机的安全操作规程 |
| 下一页 剪切机使用注意事项 |
Copyright © 技术支持：遨游网络